OSAVE
osave file name recover|<RANGE-SET> [noshare|share builder] This command will save a range of objects in much the same way that rsave saves a range of rooms. However, it will only save the objects in the specified range that are flagged as being prototypes.Ex: osave underkeep 1000 1100
If you enter osave without any options, a list of objects you have saved will be displayed.
You can use the same name for a set of rooms, objects, mobiles, and zones. (For example, the objects that go along with the "underkeep" room file could also be called "underkeep".)
Archives remember what range they were saved as. The second and successive times that you save, you can omit the range unless you wish to change it.
Ex: osave jill
WARNING! The save commands WRITE OVER the existing file, so be sure to save all the objects that belong in the specified file and not just the objects you recently changed.
If you specify the recover option, this command will swap your current archive with the one saved immediately before that. Thus this can be used to recover from a mistaken save.
Ex: osave underkeep recover
The "share" option is used to indicate that this archive should be accessible by the specified builder. Archives remember sharing so this parameter only needs to be set up once. If you would like to stop sharing this archive, or share it with someone different, enter the "noshare" option. You can specify more than one builder to share with by specifying multiple "share" options.