RSAVE

This command is used to store your rooms into a file where they will be saved after you log off or during crashes and reboots.

Ex:  rsave underkeep 1000 1100

You can use the same name for a set of rooms, objects, mobiles, and zones. (For example, the objects that go along with the "underkeep" room file could also be called "underkeep".)

Archives remember what range they were saved with. You do not need to keep specifying the range when saving.

Ex:  rsave Jill 1000 1100

WARNING!
The save commands WRITE OVER the existing file, so be sure to save all the rooms that belong in that file and not just the room numbers you recently changed.

If you specify the recover option, this command will swap your current archive with the one saved immediately before that. Thus this can be used to recover from a mistaken save.

Ex:  rsave underkeep recover

The "share" option is used to indicate that this archive should be accessible by the specified builder. Archives remember sharing so this parameter only needs to be set up once. If you would like to stop sharing this archive, or share it with someone different, enter the "noshare" option. You can specify more than one person to share with by entering more than one "share" option.